Specifications:
Operating Temperature -10°C to 50°C
Operating Humidity 0 to 95 RH, no condensation or
icing
Operating Voltage 22VDC to 30VDC
Average Current 70 mA
Light Output ≥ 1.2 WS
Flash Rate ≤ 2 seconds
Sound Level ≥ 100dB
Light Life ≥ 30000 flashs
Coded
Sound Signal 3-type:
1. Simulating the sound of the police car.
2. Simulating the sound of the fire fighting truck
3. Simulating the sound of the ambulance car.
Dimensions 185X130 X70 mm
Note: The data in the specification is tested at
24 VDC input.
General Description:
Wizmart’s new devices, the BHZ-B-1 Series Horn/Strobes,
featured low current design with reduced inrush,
can be used in different application, specially
for fire alarm application.
Using Germany-made high pressure flashing light
and high performance piezoelectric buzzer, when
activated, the device can give off strongly warning
in visible and audible way. By easily setting, there
are three different coded sound signals can be chosen.
Installation
1. At the place where you are going to install the
detector, drill two holes and insert the wall plugs.
The distance between two holes is 65 mm.
2. Using the two screws, attach the base to the
wall. The direction is shown in Fig. 2. Then draw
the wires from the hole in the base.
3. Connect wires to the terminal. Please refer to
Fig. 3. Set up the temporal pattern tone based on
your demands. The temporal pattern tone will be
sound like police car, sound like fire fighting
truck, or sound like ambulance car.
4. Install the device into the base and fix it by
a screw.
|
 |
